Please note that online and print versions of the book ordered after August 15, 2020 have been corrected with respect to the errors indicated below.

1st Edition (May 16th, 2020)

Reference Errors

  • Chapter 3
    • Page 38
      • The oldest company in sootblowing using low-frequency sound is Swedish Infrafone [48][46].
    • Page 41
      • A similar idea is used in explosion generators [50][48]
    • Page 44
      • Due to the high energy, the Explosion Generators [50][48]
    • Page 46
      • always associated with the erosion of cleaned surfaces [52][50].
      • In Ref. [53][51],
      • In Refs. [53][51] and [2].
    • Page 48
      • flue-gas and air flows occur at higher speeds [54][52].
    • Page 49
      • corrosion-resistant materials (even plastic [55][53] or glass [56][54]),
      • sometimes an interesting solution is used [57][55]:
    • Page 50
      • Typical examples of such situations are agro-biomass fired boilers [58][56].
    • Page 52
      • until conductivity steeply rises [61,62][57,62].
      • measurement of this kind requires a lot of experience [58][56].
    • Page 53
      • the co-firing of such fuels [63][58]
      • Similar diagram for co-firing biomass and coal is presented in Ref. [65][61].
    • Page 54
      • According to Ref. [66, 2][63, 2]
    • Page 55
      • Figure 3.48: Dew point of flue gas by heating oil combustion [66, 2][63, 2].
      • gas temperature was made in Ref. [67][65].
    • Page 58
      • An interesting proposition offers Ref. [68][66].
      • Therefore, also taking into account Refs. [2, 69][2, 67],
    • Page 62
      • The value of the annual rate of capital services is made, according to Ref. [70][68]
    • Page 67
      • The optimum relative humidity of flue gas is usually taken at the level of 15% [71][69].
    • Page 68
      • the POWERISE system in the supercritical CFB boiler of Łagisza Power Plant [72][70].
      • Recuperative heat exchangers [2, 72][2, 70]
    • Page 70
      • on fabric expansion joints or water sealing are used [2, 73][2, 71].
      • Systems of this kind are offered, e.g., by Magaldi [73] and Clyde-Bergemann [74][72].
    • Page 71
      • Figure 3.55: Sealing of the connection between the combustion chamber and the hopper [73][71].
    • Page 72
      • power consumption of the air fans and to optimize their selection [75][73].
    • Page 75
      • More thoroughly the problem of RAH leaks is discussed in Ref. [76][74].
  • Chapter 4
    • Page 113
      • 0.5 s [77][79].
  • Chapter 5
  • Chapter 6
    • Page 176
      • Reference [7] should point to:
        Oвчинников ЮВ, Бойко ЕЕ, Серант ФА. Проблемы сжигания водоугольных топлив и предложения по разработке технологии сжигания. Доклады АН ВШ РФ, 2015 январь–март 1(26), УДК 621.311.
  • Chapter 7
    • Page 201
      • Figure 7.20: The scheme of the power plant Avedøre 2 [76][78].
  • Chapter 8
    • Page 240
      • or the Highresist [43][42].
    • Page 243
      • Figure 8.20: Eutectic deliquescence humidity of NH4Cl and NaCl mixture [74][75].
    • Page 280
      • Reference [74] appears twice:
        [74][75] Kelly JT, Wexler AS, Chan CK, Chan MN. Aerosol...
    • Page 255
      • Figure 8.29: Erosion effect caused by wrong steam blowing [102][104].
    • Page 265
      • 10-50 μm [118][119].
  • Chapter 10
    • Page 303
      • in Refs. [31, 34][31-34].